ARZENTIQ
ELECTRICAL

Speaker Crossover Calculator

Inductor and capacitor values for a passive two-way crossover — first order, Butterworth or Linkwitz-Riley — from the frequency and driver impedances.

The woofer’s low-pass inductor (and shunt capacitor) and the tweeter’s high-pass capacitor (and shunt inductor) in mH and µF, the slope, and whether the tweeter needs reversed polarity.

Example: A second-order Linkwitz-Riley crossover at 2,500 Hz into 8 Ω drivers needs 1.02 mH and 3.98 µF on each side, with the tweeter wired in reverse polarity.

v0.1.0 · last reviewed 24 September 2026
Loading the workspace…
BUILT TO BE UNDERSTOOD

Frequency and
impedance.

The three alignments and their formulas, why second-order sections flip the tweeter, and what a real driver’s impedance does to textbook values.

First order

A single series inductor on the woofer and a series capacitor on the tweeter roll off at 6 dB per octave: L = R ÷ 2πf and C = 1 ÷ 2πfR, with R the driver’s nominal impedance.

Second order

Adding a shunt element gives 12 dB per octave. Butterworth (Q 0.707) uses L = √2·R ÷ 2πf and C = 1 ÷ (2√2·π·f·R); Linkwitz-Riley (Q 0.5) uses L = R ÷ πf and C = 1 ÷ 4πfR, and its two outputs sum flat. Each second-order section shifts phase 180° between the drivers at the crossover, so the tweeter is wired in reverse.

What the number does not settle

The formulas assume a resistive load. A real driver’s impedance rises with frequency, so designers add a Zobel network, pad the tweeter to match levels, and measure; choose standard component values near these and check the response. Inputs stay in your browser; the same anonymous usage counts as the rest of the site apply.